INSTRUCTIONS FOR USING THE PARA 150 X
Firstly, attach the lead 3.5 Jack plug to the Zapper jack plug socket. After that attach the crocodile clips onto each copper rod. Press the sections at the other end of the Jaw section and when the 'teeth' are open clip onto the copper rods.
As you see the device has two LED lights just below the screen panel. The green LED light on the right side indicates that the device is powered up. The other LED on the left side will light up red colour if the battery needs changing. The very latest version now has a high pitched signal that indicates that the battery needs changing. You can obtain a charger and PP3's rechargable batteries if you are using the unit a lot. It would be good to have two PP3's so that one can always be charged, (we do not supply the chargers or the PP3's)
On the front side there are two switches and terminal sockets for the leads. The first switch printed with white marks I-O is for switching on/off of the device. The other round black button is for starting and stopping the frequency signal from the device to the Copper Hand Holds. Press the button IN to start the frequency flow, press button OUT to stop the flow. Try not to allow the copper rods to touch each other for any length of time.
To Repeat.
The On/Off switch is the top rocker switch and the round black button is to switch the frequencies ON. You can pause this by pressing the button again to stop the frequencies at any time. So when the button is IN, it is working, when the button is OUT it is off.
The basic frequencies you can set up are:
15Hz, 528Hz, 1.00kHz, 2.50kHz, 30.0kHz...etc. Many Dr Royal Rife frequencies can be found online as well.
On the LCD panel there are 4 buttons, 2 on the left and 2 on the right side. On the left-hand side are two buttons to increase or decrease the frequency output, on the right side they are for increasing and decreasing the frequency duty cycle. Some users have used a piece of Kitchen roll around each Copper Hand Hold and dampened it and say it has better contact with the skin and better frequency penetration. Further information about the Dr Hulda Clark protocol, can be found here:
https://www.zappertek.com/page/dr-hulda-clark-protocol
Please be aware:
For normal use the duty cycle (frequency power) should always be set at 50%. If your body can stand more power than 50%, you can increase it. It can help deeper signal penetration. If you are very sensitive to the power turn the signal down to less than 50% and this lower signal should be used by sensitive persons to start off with.
Also notice that these units are for experimental use only and Zomatron cannot be held responsible for using any of our devices for serious or not so serious illnesses or disease conditions.
The batteries are standard Alkaline PP9 available World Wide. Just use a Screwdriver to undo the battery compartment and replace the battery and return the screws to their positions.
DO NOT USE If pregnant or wear a Pacemaker. Please drink water whilst zapping and afterwards.
http://electroherbalism.com/Bioelectronics/FrequenciesandAnecdotes/CAFL.htm
