COLLOIDAL SILVER GENERATOR INSTRUCTIONS
Firstly many thanks for purchasing your Anti-Bacterial Generator. Package contains 1 Generator, 2 Silver rods and a PPM tester.
Place the rods into the connects attached to the Generator and make sure they are parallel to each other. Only use Distilled or Battery type water that is very pure. In the UK we use CarPlan water as used in batteries and steam irons.
Make sure to use a clear glass and keep the rods slightly above the water. Do not allow the rod connects to touch the water.
Do not use Salt or any other substance in the water, it will not be pure enough. Plug the AC/DC adaptor into the wall socket and switch on. Every so often dip the PPM tester into the water and check the strength of the Colloid. We use it between 2-5 PPM, the longer you leave it switched on, the greater amount of particles of Silver will be released into the water.
We cannot give an exact time to produce Colloidal Silver as it depends on atmospheric conditions and other factors. Usually around 20 Minutes for a lower strength, so to use the tester press the On/Off switch and when it is placed into the water, press the 'hold' button, then take it out of the water and that will give you the PPM reading.
Each time you produce a batch of Silver, make sure the rods are kept clean with a washing up sponge with a rough side. Use the rough side to polish off any tarnish from the rods.
Make sure all the wire rods are cleaned after each use with the rough side of a washing up sponge. Also make sure wires are as straight as they get.
Keep the terminals of the C/S machine out of the water.
Only use ultra clean water, such as used in Steam Irons or Car Batteries.
Test the water first to ascertain the PPM within the water and then place the C/S unit above the glass with water in, making sure the water does not cover the electrical terminals. Then switch on at the mains, using the AC/DC adaptor.
Keep checking the PPM of the Silver Water and when it gets to 3-5 PPM then you have to decide what strength you want it to be. Leaving it on, will get far more PPM. We only use the 3-5 PPM strength.
When finished make sure the C/S is placed into a dark container and keep it in a dark place.
Make sure all the wire rods are cleaned after each use with the rough side of a washing up sponge. Also make sure wires are as straight as they get.
Keep the terminals of the C/S machine out of the water.
Only use ultra clean water, such as used in Steam Irons or Car Batteries.
Test the water first to ascertain the PPM within the water and then place the C/S unit above the glass with water in, making sure the water does not cover the electrical terminals. Then switch on at the mains, using the AC/DC adaptor.
Keep checking the PPM of the Silver Water and when it gets to 3-5 PPM then you have to decide what strength you want it to be. Leaving it on, will get far more PPM. We only use the 3-5 PPM strength.
When finished make sure the C/S is placed into a dark container and keep it in a dark place.
Make sure you switch off the Unit, before removing the Silver rods from the water.
Good Health to you.
